Testing tool assistance Ferri-Check

Wash your hands thoroughly. Use soap and warm water.
Dry your hand with clean towel.

Prepare the test device and capillary pipette: Take them out from the protective pouch (tear at the notch) and place them in the reach of your hands (you will need them later). Discard the desiccant bag.

Prepare the lancet. Hold the lancing device without touching the trigger button. Unlock the cap twisting it off ¼ turn until you feel it separates from the lancing device and then continue twisting it (2-3 rotations). Don’t pull just twist and discard the cap when finished.

Clean the end of the middle or ring finger with cotton damped with alcohol. Massage the chosen finger towards the tip for 10 to 15 seconds to enhance the blood flow.

Prick the finger: put the lancing device firmly against the side of the previously cleaned fi nger, and press the release trigger button. The lancet will automatically retract into the body of the device. Gently massage the fi nger to create a nice round blood droplet.

Collect the blood with the capillary pipette: Gently touch the blood droplet with the open end of the capillary pipette. It must be fi lled until the line indicated on the capillary tube. Do not press the balloon, it fi lls by itself. Make another blood droplet if the line is not reached. As far as possible, avoid air bubbles

Put the blood collected with the capillary pipette into the sample well of the device, by pressing on the pipette balloon. Wait 30-40 sec for the blood being totally absorbed into the sample well.

Add the diluent: Unscrew the blue cap of the diluent dropper bottle (leave the white cap tightly screwed) and add the diluent as follows: Hold the diluent dropper bottle vertically and slowly add exactly 4 drops in the sample well of the device with an interval of 2-3 seconds between each drop.

Read the result after 10 minutes. Do not interpret after 15 minutes.